Meridian 588 User's Guide download pdf (Page 14)

Using the compact disc player

Switching on and off

During normal use the compact disc player should be left in the

standby state. This uses a negligible amount of electricity, but

ensures that the components operate at maximum efficiency

from the moment you start playing a disc.

If you are not going to use the compact disc player for a period

of several days you should switch the unit completely off, at the

back panel, and disconnect it from the AC power supply.

To switch on from standby

● Press Open, *, or > (front panel), or select a source on the

remote.

● Switch on any other equipment connected to the compact

disc player which is not part of the Meridian 500 Series.

The display will flash for a few seconds. The compact disc

player is then ready for use.

To insert a disc

● Press Open (front panel) or Function * (remote) to open the

tray.

● Place your disc, label side up, in the tray as shown opposite.

● Press Open (front panel), Function * (remote), or > to close

the tray.

To switch to standby

● Press Off.

The display will show:

If you have other Meridian 500 Series equipment connected to

the compact disc player, these units will also switch to standby.

If a disc is currently playing, switching to standby will stop the

disc, and the disc can safely be left in the unit.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 40 41

No comments

Meridian 588 User's Guide Page 14