Meridian 586 User's Guide download pdf (Page 65)

Setting up the DVD player

This section describes problems you may encounter when using

the DVD player, and includes suggested solutions.

If these suggestions fail to cure the problem, please contact

your Meridian dealer for further assistance.

No lights are displayed when

switching on

❍ Check that your AC power supply is connected correctly.

❍ Check that the ON/OFF switch on the back panel is in the ON

position.

There is no sound when playing a disc

❍ Check that your preamplifier is switched on, and the volume is

at an appropriate level.

❍ Check that the DVD player is connected correctly to the other

components of your system; see Setting up the DVD player,

page 53.

❍ Check that the correct source has been selected on your

preamplifier.

❍ Check that the display does not show Pause.

❍ Try playing another disc. If this disc works, check the problem

disc for signs of dirt or damage.

❍ If you are using the DVD player with a preamplifier or active

loudspeakers check that the AUDIO OUT SEL. menu option is

set to PCM; see To select the audio output format, page 37.

There is interference on the radio and/

or television when the DVD player is

switched on

Before following the steps below, ensure all units are switched

off first.

If this equipment does cause or suffer from interference to/from

radio or television reception then the following measures should

be tried:

❍ Reorient the receiving aerial (or antenna) or route the antenna

cable of the receiver as far as possible from the 586 DVD

Player and its cabling.

❍ Ensure that the receiver uses well-screened antenna cable.

❍ Relocate the receiver with respect to the DVD player.

❍ Connect the receiver and this product to different AC outlets.

Troubleshooting

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 73 74

No comments

Meridian 586 User's Guide Page 65