Meridian G61 Installation Guide download pdf (Page 50)

Troubleshooting

We expect you to achieve superb results with your digital surround controller. If, however, you

encounter any problems, either when installing and configuring it, or during operation, please

check the following pages for suggested solutions.

If these suggestions fail to cure the problem, please contact your Meridian dealer for further

assistance.

General operating problems

Standby light not lit

• Check that the AC power supply is connected correctly.

• Check that the ON OFF switch on the back panel is in the ON

position.

If the light still does not illuminate, check any fuses in your power

supply and the fuse in the inlet of the G61. If these are all intact,

contact your dealer.

Erratic or unexpected system behaviour

Redo the Auto Configure process as follows:

• Put the whole system into standby.

• Make sure you are operating the MSR+ from a position where all

the units can receive the infra-red.

• Press Clear on the MSR+.

• Observe all units responding correctly.

In extreme cases, the memory of the G61 may have been

corrupted. If this is suspected perform a full reset; see

Resetting the

product

, page 16.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 58 59

No comments

Meridian G61 Installation Guide Page 50