Meridian G68 Installation Guide download pdf (Page 29)

I n s t a l l i n g t h e

d i g i t a l s u r r o u n d

c o n t r o l l e r

2 5

To connect to other Meridian G Series, 500 Series, or 800 Series equipment

COMMS

COMMS LEAD COMMS LEAD

G Series or 800 Series unit

COMMS

G68 Digital Surround Controller

In a system of Meridian products the products should be linked

together in a chain, via the COMMS sockets, using the Comms

leads supplied with each product. The sequence in which you

connect the units is not important.

One of the products acts as the controller for the system, receiving

infra-red commands from the MSR+, and then, if appropriate,

relaying them to the other products via the Comms link. The

following procedure should be used to set up the Comms correctly

between several products:

• Switch all the units to standby.

• Press

Clear (MSR+).

Each unit will display:

Auto

One unit will then be designated as the controller, and display:

Con.

All the other units will be configured as non-controllers, and

display:

Not Con.

The system is now ready for use.

If the automatic setup does not work, first make sure you are

operating the MSR+ from a position where all the units can receive

the infra-red, and try again. Then:

• Check that none of the units have been configured to be IR

Controller; see

Settings

, page 35. Either all products should be

set to Auto, or one should be configured as Controller and the

others as Not Controller.

Note: Do not, under any circumstances, connect any equipment

other than Meridian G Series or 800 Series to any socket marked

COMMS on the back of the product.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 71 72

No comments

Meridian G68 Installation Guide Page 29