Meridian 566 Specifications download pdf (Page 20)

Setting up the Digital to Analogue Converter

The Digital to Analogue Converter is initially set up so that you

select the digital input you want by pressing the appropriate key

on the front panel.

If you are using the 566 24-Bit Digital to Analogue Converter in

conjunction with a 501/501V Control Unit or 502 Analogue

Controller you can configure the Digital to Analogue Converter

so that it uses the COMMS signal to select the correct input

automatically when you choose a particular source on the

Control Unit.

To configure the Digital to Analogue

Converter

● Connect the 566 24-Bit Digital to Analogue Converter to the

other 500 Series units, making sure you connect the COMMS

sockets; see To connect to other Meridian 500 Series

equipment, page 14.

● Switch off the Digital to Analogue Converter, using the power

switch on the back panel.

● Switch on the other units in the system.

● Switch on the Digital to Analogue Converter while holding

down the key corresponding to the first digital input you want

to configure; for example D2.

The corresponding indicator

will flash:

● Using the Meridian System Remote, select the source that

should select this input; for example, CD.

The indicator will stop flashing.

● Press the key corresponding to the next digital input you want

to configure, followed by the next source you want to

associate with it, and repeat for any other sources you want to

configure.

When you have programmed all the sources you want to

configure:

● Press Phase to return the Digital to Analogue Converter to

normal operation, or switch it off using the power switch on

the back panel.

Configuring the Digital to Analogue Converter

Lock 44kHz

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 26 27 28

No comments

Meridian 566 Specifications Page 20