Meridian 566 Specifications download pdf (Page 21)

Setting up the Digital to Analogue Converter

Note that you should not configure any of the analogue sources

connected directly to the Control Unit in your system. Otherwise

selecting one of these will change the digital input on the Digital

to Analogue Converter which could interrupt a source you are

tape recording.

To reset the Digital to Analogue

Converter

You can reset the Digital to Analogue Converter to its initial

configuration using the following procedure:

● Turn off the Digital to Analogue Converter, using the power

switch on the back panel.

● Turn on the power again while holding down the Phase key

on the front panel.

All the indicators on the front panel will be illuminated for one

second.

The inputs will be programmed so that they are only selected by

the appropriate front panel key.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 27 28

No comments

Meridian 566 Specifications Page 21