Meridian RGB-T-0 Installation Guide download pdf (Page 28)

To connect to other Meridian G Series, 500 Series, or 800 Series equipment

COMMS

COMMS LEAD COMMS LEAD

G Series, 500 Series, or 800 Series unit

COMMS

G Series DVD player

In a system of Meridian products the products should be linked

together in a chain, via the COMMS sockets, using the Comms

leads supplied with each product. The sequence in which you

connect the units is not important.

One of the products acts as the controller for the system, receiving

infra-red commands from the MSR+, and then, if appropriate,

relaying them to the other products via the Comms link. The

following procedure should be used to set up the Comms correctly

between several products:

• Switch all the units to standby.

• Press Clear (MSR+).

Each unit will display:

Auto

One unit will then be designated as the controller, and display:

Con.

All the other units will be configured as non-controllers, and

display:

Not Con.

The system is now ready for use.

If the automatic setup does not work, first make sure you are

operating the MSR+ from a position where all the units can receive

the infra-red, and try again. Then:

• Check that none of the units have been configured to be

IR Controller; see

Resetting the DVD player

, page 27, and

Configuring settings

, page 46. Either all products should be set

to Auto, or one should be configured as Controller and the others

as Not Controller.

Note: Do not, under any circumstances, connect any equipment

other than Meridian G Series, 500 Series, or 800 Series to the

socket marked COMMS on the back of the product.

Installing the

DVD player

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 66 67

No comments

Meridian RGB-T-0 Installation Guide Page 28