Meridian RGB-T-0 Installation Guide download pdf (Page 40)

Configuring

the DVD player

The Gamma correction affects the grey scale, and can be set

to 1.0, 0.8, 0.9, or 1.1. If the picture has poor detail in the dark

areas choose a Gamma correction below 1.0. If the picture

has poor detail in the light areas choose a Gamma correction

greater than 1.0.

The Sharpness can be set to Off, Low, Medium, or High. It

adds edge detail, but can cause picture artefacts.

Gamma correction and Sharpness only affect the analogue

outputs.

Display aspect allows you to perform aspect ratio conversion on

the scaled outputs; ie progressive analogue or HDMI. Set Display

aspect to the shape of your screen, or Native to disable aspect

ratio conversion.

Component output allows you to choose what is available on

the component output socket. Standard Definition gives an SD

interlaced component signal. Scaled gives a deinterlaced signal;

for this option the Scaler mode should be set to Deinterlace.

To set the HDMI options

• Highlight HDMI options… in the Video setup menu, and

press Enter.

The HDMI setup menu is displayed:

• Press A or V to highlight the setting you want to change, and

press Enter.

• Set HDMI switch to On if using an HDMAX 421 switcher on

the HDMI output, or Off otherwise.

The Colour space can be set to RGB or YCrCb.

Information… provides information about the capabilities (the

EDID) of the connected HDMI display device.

The Audio source option only appears on the G91A and allows

you to specify the source of the audio on the HDMI connector.

Preamp takes it from the DVD player preamplifier output, and

Transport takes it direct from the DVD audio.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 66 67

No comments

Meridian RGB-T-0 Installation Guide Page 40